U D Sing The Dr Mode Scan - Icom ID-51A Advanced Instructions

Previous view
8
D-STAR OPERATION <BASIC>
"FROM" (Access repeater) setting (Continued)
■
D Using the DR mode scan
The DR mode scan is useful to find a repeater.
To quickly find a repeater, the DR mode scan skips re-
peaters that are not specified as an access repeater.
("USE (FROM)" setting is "NO" (SKIP is set) on the re-
peater list.)
Hold down for 1 second.
q
• The DR mode is selected.
Hold down [SCAN]
w
• The frequency decimal point and "FROM" blink while
scanning.
• The repeaters in the repeater list are sequentially dis-
played.
• The scan pauses when a signal is received. The scan
resumes the same as other scanning. (p. 16-18)
When the transceiver receives a signal from a re-
e
peater, the scan stops, then push [CLR]
• The DR mode scan is cancelled.
You can skip certain repeaters from a scan target.
You can also skip all repeaters in certain groups from
a scan. See page 9-37 for details.
NOTE:
Even if the transceiver receives a signal from a re-
peater, the repeater may not receive the transceiv-
er's signal, because the repeater's output power is
higher than the transceiver's.
The DR mode scan scans simplex frequencies if they
are entered in the repeater list.
While receiving a
Blinks
signal on 433.450.
to start the DR mode scan.
.
Example: Select the "Hirano repeater using the
DR mode scan.
"FROM" is selected.
While DR mode scanning
Blinks
While receiving a signal from a repeater
Completed
8-4
The repeaters
are sequentially
displayed.
Means "JM1ZLK" is
using the "Hirano"
repeater.