Memory Channel Programming; D Programming In Vfo Mode - Icom IC-718 Instruction Manual

6
MEMORY OPERATION

Memory channel programming

Memory channel programming can be preformed ei-
ther in VFO mode or in memory mode.

D Programming in VFO mode

q Set the desired frequency, operating mode and fil-
ter width in VFO mode.
w Push [∫]/[√] several times to select the desired
memory channel.
• Memory list screen is convenient for selecting the de-
sired channel.
• Memory channel contents appear in the memory chan-
nel readout (below the frequency readout).
• "--.---.--" appears if the selected memory channel is a
blank channel (and does not have contents).
e Push and hold [MW] for 1 sec. to program the dis-
played frequency, operating mode, etc., into the
memory channel.
D Programming in memory mode
q Select the desired memory channel with [∫]/[√] in
memory mode.
• Memory channel contents appear in the memory chan-
nel readout instead of the frequency readout.
• No indication appears if the selected memory channel
is a blank channel (and does not have contents).
w Set the desired frequency and operating mode in
memory mode.
• To program a blank channel, use direct frequency entry
with the keypad or memo pads, etc.
e Push and hold [MW] for 1 sec. to program the dis-
played frequency and operating mode into the
memory channel.
101
[EXAMPLE]:
Programming 7.088 MHz/LSB into memory channel 12.
[EXAMPLE]:
Programming 21.280 MHz/USB into memory channel 19.
(p. ??)
7
SSB
3
or
Beep
MW
Push for 1 sec.
Beep
Beep
or then 21
7
Beep
MW Push for 1 sec.
Beep
Beep
MW
SSB