To" (Destination) Setting - Icom ID-51A Advanced Instructions

Previous view
8
D-STAR OPERATION <BASIC>
■ "TO" (Destination) setting
The destination repeater or station must be set to "TO"
when you transmit a call in the DV mode.
You have seven ways to set the destination.
Click the title as shown below to jump to the specified
page.
NOTE: After you receive the repeater's signal, the
calling station's call sign can be captured by holding
down the Call Sign Capture key (
quickly and easily reply to a received call.
To make a Local Area CQ call
1: "Local CQ" setting (p. 8-9)
Set "CQCQCQ" in "TO" (Destination).
To make a Gateway CQ call
2: "Gateway CQ" setting (p. 8-10)
Select a repeater from the repeater list.
To make a call to a specific station
3: "Your Call Sign" setting (p. 8-11)
Select the station call sign in the Your Call Sign
memory.
When the destination data is stored in the RX History
4: Setting from the RX History (p. 8-12)
When you receive a call, the calling station data is
stored in the RX History.
You can select the destination from the record.
When the destination data is stored in the TX History
5: Setting from the TX History (p. 8-13)
When you transmit a call, the destination repeater or
station data is stored in the TX History.
You can select the destination from the record.
To directly input the destination station call sign
6: Direct Input (UR) (p. 8-14)
Directly input the destination station call sign.
To directly input the destination repeater call sign
7: Direct Input (RPT) (p. 8-15)
Directly input the destination repeater call sign.
"Hamacho" repeater
is set in "TO."
), and you can
8-8
[TO SELECT] screen
How to switch the repeater group:
When "Local CQ" or "Gateway CQ" is se-
lected, you can switch the repeater group.
While in the DR mode, push [QUICK]
➥
to open the Quick menu. Then
push D-pad( ) to select "Group Select."

• You can switch the repeater group using
D-pad()