New Repeater Programming - Icom ID-51A Advanced Instructions

Previous view
9
D-STAR OPERATION <ADVANCED>
■ Repeater list programming
This section describes how to manually program new
repeater into the repeater list.
The required setting items differ, depending on the re-
peater use. Be sure to confirm the required items, as
shown to the right.
NOTE: To program a repeater into the repeater list,
the repeater's call sign MUST be entered.
D New repeater programming
1. Repeater group selection
q Push [MENU] .
w Push D-pad( ) to select the root item ("DV Memo-

ry"), and then push D-pad(Ent).
D-pad
(Ent)
(�)
e Push D-pad( ) to select "Repeater List," and then

push D-pad(Ent).
• The repeater groups are displayed.
r Push D-pad( ) to select the desired repeater group

to be programmed, and then push D-pad(Ent).
• The repeater list of the selected repeater group is dis-
played.
t Push [QUICK] .
y Push D-pad( ) to select "Add," and then push D-

pad(Ent).
• The REPEATER LIST EDIT screen is displayed.
* When you want to add a new repeater by editing a pro-
grammed repeater memory contents, select "Edit." In this
case, after programming, be sure to select "<<Add Write>>."
If you select "<<Overwrite>>," the original repeater pro-
grammed contents are overwritten.
D Required items for the communication cases
Used as
Repeater list
an access
contents
repeater
NAME
SUB NAME
CALL SIGN
GW CALL
SIGN
(For Gateway call)
GROUP
USE(FROM)
FREQUENCY
DUP
OFFSET FREQ
POSITION
LATITUDE
LONGITUDE
UTC OFFSET
9-23
Used as a Used for a
destination simplex com-
repeater munication
– –
– –
This item MUST
✔ ✔
be blank.
✔
✔
– –
–
✔
–
✔
This item MUST
–
✔
be set to "OFF."
–
✔
– –
– –
– –
– –
☞ Continued on the next page.
–
–
–
–
✔
✔
–
–
–
–
–
Select
*