D Turning On The Gps Logger Function; D Setting The Gps Record Interval - Icom ID-51A Advanced Instructions

Previous view
10
GPS/GPS-A OPERATION
GPS Logger function (Continued)
■

D Turning ON the GPS Logger function

Turn the GPS logger function ON or OFF, to store your
route as you move.
When the GPS Logger function is set to ON, the trans-
ceiver stores the position data from GPS receiver into
microSD card in a specified time interval.
While using the Internal GPS receiver only four GPS
sentences, GGA, RMC, GSA and VTG, are used.
Push [MENU] .
q
Push D-pad( ) to select the root item ("GPS"), and
w
then push D-pad(Ent) to go to the next screen.
D-pad
(Ent)
(�)
(MENU > GPS > GPS Logger > GPS Logger)
Refer to the menu sequence shown directly above,
e
and push D-pad() to select, and then D-pad(Ent)
to enter, one or more times until the last screen is
displayed.
Push D-pad( ) to select "ON."
r
Push [MENU] to exit the Menu screen.
t
• The GPS Logger starts.
NOTE:
While using the external GPS receiver, uses only the
compatible GGA, RMC, GSA and VTG sentences.

D Setting the GPS record interval

For example, when you are walking and if the time in-
terval is set to "1sec," a lot of position data is stored
at almost same place. Select the GPS Logger function
record interval to suit your travel speed. (Default: 5sec)
Push [MENU] .
q
Push D-pad( ) to select the root item ("GPS"), and
w
then push D-pad(Ent) to go to the next screen.
D-pad
(Ent)
(�)
(MENU > GPS > GPS Logger > Record Interval)
Refer to the menu sequence shown directly above
e
and push D-pad() to select, and then D-pad(Ent)
to enter, one or more times until the last screen is
displayed.
Push D-pad( ) to select a desired record interval.
r
• Selectable settings are 1, 5, 10, 30 or 60 seconds.
Push [MENU] to exit the Menu screen.
t
10-26
GPS LOGGER screen
Select
*
* The transceiver has an exclu-
sive GPS logger mode where
only the logger is functioning.
See page 10-29 for details.
Record Interval
screen