Memory Bank; D Directly Programming Into A Memory Bank - Icom ID-51A Advanced Instructions

Previous view
12
MEMORY CHANNEL PROGRAMMING
Memory bank setting
■ (Continued)
Directly programming into a memory bank
D
You can also program the memory contents directly
into a memory bank channel. This way is a short cut to
programming the memory channel, and then assigning
it to a bank. In that case, the transceiver automatically
selects the lowest blank memory channel, to program.
Push [V/MHz] to select the VFO mode.
q
Set a desired frequency and operating mode:
w
Rotate [DIAL] to set a desired frequency.
➥
(Example: 146.010 MHz)
Push [MODE]
➥
desired operating mode. (Example: FM mode)
Set duplex direction, frequency offset, tone squelch
➥
and so on, if desired.
Hold down [S.MW]
e
lect Memory write mode.
• 1 short and 1 long beep sound.
• The memory channel number blinks, and memory con-
tents are displayed.
Push [QUICK] to open the Quick Menu screen.
r
Push D-pad( ) to select "Bank Select," and then
t
push D-pad(Ent).
D-pad
(Ent)
(�)
Rotate [DIAL] to select a desired bank group, "A" to
y
"Z," and then push D-pad(Ent). (Example: "J")
• If you want to change the bank group after pushing
D-pad(Ent), return to step r.
Rotate [DIAL] to select a desired bank channel be-
u
tween "00" and "99." (Example: "01")
• The bank channel number blinks.
• If the selected bank channel is already assigned, the
memory contents are displayed.
Hold down [S.MW]
i
then return to the VFO mode.
• 3 beeps sound.
• If an already assigned bank channel is selected in step
u, the memory contents will be overwritten into the
memory channel and bank channel.
• The Bank channel number automatically increases when
continuing to hold down [S.MW]
NOTE: Push [CLR]
exit the Select Memory write mode before memory
programming.
NOTE: If the Memory bank display is already select-
ed and you want to program the contents into the
memory channel, do the following steps:
q Select "ALL CH Select" in
step t.
w Rotate [DIAL] to select a
desired memory channel.
e Hold down [S.MW]
1 second to program.
one or more times to select a
for 1 second to enter the Se-
for 1 second to program, and
after programming.
to cancel the program and
for
Example: Programming 146.010 MHz/FM mode into
Memory bank channel J-01.
12-8
Hold down [S.MW]
for 1 second to enter
the Select Memory write
mode.
Push D-pad() to select
"Bank Select."
Rotate [DIAL] to select
the bank group, "J."
The bank channel num-
ber blinks.
Rotate [DIAL] to select
the bank channel "01."
Hold down [S.MW]
for 1 second to program.
Returns to the VFO mode.