Icom ID-51A Advanced Instructions page 197

Previous view
12
MEMORY CHANNEL PROGRAMMING
■ Memory clearing
Contents of programmed memories can be cleared
(erased), if desired.
Hold down [S.MW]
q
lect Memory write mode.
• 1 short and 1 long beep sounds.
• The memory channel number blinks.
• DO NOT hold down [S.MW]
onds.
Rotate [DIAL] to select a desired memory channel
w
to be cleared.
• Select Call channels (C0 to C3) to erase a call channel,
or scan edge channels (0A/0B to 24A/24B) to erase a
scan channel.
Push [QUICK] to open the Quick Menu screen.
e
Push D-pad( ) to select "Clear," and then push D-
r
pad(Ent).
• The confirmation screen "Clear?" appears.
D-pad
(Ent)
(�)
Push D-pad( ) to select "YES," and then push D-
t
pad(Ent) to clear the contents.
• After clearing, the display returns to the Select Memory
write mode.
• To cancel the memory clearing, select "NO" and push D-
pad(Ent.)
Push [CLR] to exit the Select Memory write
y
mode.
• Returns to the previous screen viewed before entering
the Select Memory write mode in step q.
for 1 second to enter the Se-
for more than 2 sec-
[DIAL]
Example: Clearing the memory channel 007.
12-13
In the Select Memory
write mode, rotate [DIAL]
to select the memory
channel to be cleared.
Push [QUICK] , and
push D-pad() to select
"Clear," then push
D-pad(Ent).
Push D-pad() to select
"YES," and then push D-
pad(Ent) to clear.
Returns to the Select
Memory write mode.
Push [CLR] to
return to the screen
viewed before entering
the Select Memory write
mode.