D Directly Inputting (Rpt) - Icom ID-51A Advanced Instructions

Previous view
8
D-STAR OPERATION <BASIC>
"TO" (Destination) setting (Continued)
■

D Directly inputting (RPT)

The destination repeater call sign can be directly input.
Hold down for 1 second.
q
• The DR mode is selected.
Push D-pad( ) to select "TO," and then push D-
w

pad(Ent).
D-pad
(Ent)
(�)
Push D-pad( ) to select "Direct Input (RPT)."
e 
Push D-pad(Ent) to enter the edit mode.
r
Rotate [DIAL] to select a desired character.
t
(Example: J)
• A to Z, 0 to 9, / and a space can be selected.
• Rotate [DIAL] counter clockwise to enter a space.
• Push [CLR] to delete the selected character, or hold
down [CLR] to continuously erase the characters,
first to the right, and then to the left of the cursor.
Push D-pad( ) to move the cursor to the second
y
digit.
Repeat steps t and y to enter a name of up to 8
u
characters, including spaces.
(Example: First, J, then P, then 3, then Y, then D,
then H.)
After entering, push D-pad(Ent) twice.
i
• "JP3YDH" is displayed on "TO."
• After programming, you can correct the call sign in the
DIRECT INPUT (RPT) screen.
• The programmed call sign remains on the DIRECT IN-
PUT (RPT) screen, until inputting a new call sign.
If the programmed call sign is duplicated to the re-
peater list, the name is displayed. (Only when the
name has been programmed.)
[DIAL]
8-15
Example: Directly input the call sign "JP3YDH"
Completed
The following settings are also correct.
The repeater node*
is input.
* Although the repeater node letter is 'B' for 430 MHz band,
'A' is used in Japan. See page 8-1 for details.
"/" is input.
In this case, the call sign is of
a repeater for a Gateway call.