Programming Memory/Bank/Scan Name; D Programming Memory Name, Bank Name Or - Icom ID-51A Advanced Instructions

Previous view
12
MEMORY CHANNEL PROGRAMMING

■ Programming memory/bank/scan name

Each memory channel can be programmed with an al-
phanumeric channel name for easy recognition. Names
can be a maximum of 16 characters.
NOTE: Only one name can be programmed for each
bank. Therefore, the previously programmed bank
name will be displayed when bank name is selected.
Also, the bank names are automatically updated in oth-
er memory channels assigned to the same bank
group.
D Programming memory name, bank name or scan name
Hold down [S.MW]
q
lect Memory write mode.
• 1 short and 1 long beep sounds.
• The memory channel number blinks.
• DO NOT hold down [S.MW]
Rotate [DIAL] to select a desired memory channel.
w
• Select Call channels (C0 to C3) to program a Call chan-
nel name, or Scan edge channels (0A/0B to 24A/24B) to
program a scan name.
Push [QUICK] to open the Quick Menu screen.
e
Push D-pad( ) to select "Edit," and then push D-
r
pad(Ent) to enter the name programming mode.
D-pad
(Ent)
(�)
Push D-pad( ) to select "MNAME," "BNAME" or
t
"SNAME," and then push D-pad(Ent).
• MNAME" is for a memory name, "BNAME" for a bank
name or "SNAME" for a scan name.
• If the selected memory channel's name has already been
programmed, the name is displayed.
• "BNAME" appears only when the selected memory chan-
nel is assigned to a bank.
• "SNAME" appears only when the selected memory chan-
nel is a scan edge channel. The same name is automati-
cally assigned to both scan edge channels, A and B.
• After pushing D-pad(Ent), the cursor blinks on the first
digit.
NOTE: When entering the scan type selection mode,
the programmed Scan name is displayed instead of
the frequency range indication.
for 1 second to enter the Se-
for more than 2 seconds.
[DIAL]
Example: Programming the memory name
M-CH000.
Continued on the next page
12-10
in
"ID-51"
In the Select Memory
Write mode, select
M-CH000, and then
push [QUICK] .
Push D-pad() to select
"Edit," and then push
D-pad(Ent).
Push D-pad() to select
"MNAME."
The cursor blinks on the
first digit.