Skip Setting For The Dr Mode Scan; D Individual Skip Setting - Icom ID-51A Advanced Instructions

Previous view
9
D-STAR OPERATION <ADVANCED>

■ Skip setting for the DR mode scan

You can set unnecessary repeaters as scan skip tar-
gets. The selected repeaters are skipped during scan-
ning for faster selection and scanning.
You can set the skip setting to all repeaters in the se-
lected repeater group, or the individual repeater.
When a repeater is specified as a skip target, its
"USE (FROM)" setting is automatically set to "NO." In
this case, the repeater cannot be selected in "FROM"
(Access repeater).

D Individual skip setting

Push [MENU] .
q
Push D-pad( ) to select the root item ("DV Memo-
w 
ry"), and then push D-pad(Ent).
D-pad
(Ent)
(�)
Push D-pad( ) to select "Repeater List," and then
e

push D-pad(Ent).
Push D-pad( ) to select the repeater group that in-
r

cludes the repeater you want to set the skip setting
on, and then push D-pad(Ent).
Push D-pad( ) to select the repeater to be skipped
t 
during the DR mode scan.
Push [QUICK] .
y
Push D-pad( ) to select "SKIP," and then push D-
u 
pad(Ent).
• "SKIP" appears on the selected repeater.
• Push [QUICK] and select "SKIP" again, then push
D-pad(Ent) to cancel the skip setting.
• When "SKIP All ON" is selected, push D-pad(Ent) to set
all repeaters in the group as skip targets.
While in the DR mode, and
if you select "Repeater List"
on the FROM SELECT
screen, you can set the skip
settings in the same way as
described above.
9-36
Select the repeat-
er group.
Select the repeat-
er to set the skip
setting
Appears