Icom ID-51A Advanced Instructions page 118

Previous view
9
D-STAR OPERATION <ADVANCED>
Repeater list programming (Continued)
■
14. UTC Offset programming
UTC (Universal Time Coordinated) offset is the time
difference between UTC and repeater local time. This
item enables you to check the destination repeater's
time when you make a gateway call. (p. 9-39)
%7 Push D-pad( ) to select "UTC OFFSET," and then

push D-pad(Ent) to enter the UTC offset edit mode.
D-pad
(Ent)
(�)
%8 Rotate [DIAL] to input the time difference between
UTC and the local time.
%9 After entering, push D-pad(Ent).
15. Storing the repeater list
^0 Push D-pad( ) to select "<<Add Write>>," and then

push D-pad(Ent).
^1 Push D-pad( ) to select "YES," and then push D-

pad(Ent).
• The programmed contents are stored to the repeater list,
and the display returns to the RPT LIST screen.
To cancel the programmed data:
To cancel the programmed
data, push [CLR]
display "Cancel edit?." Push
D-pad( ) to select "YES,"

and then push D-pad(Ent)
to cancel programming and
the display returns the RPT
LIST screen.
to
* "<<Overwrite>>" appears when "Edit" is selected
in [1. Repeater group selection].
9-31
Select
*