Chrysler 2005 Crossfire SRT6 Service Manual page 464

5 - 298 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1330-BAS SOLENOID VALVE CIRCUIT (CONTINUED)
2.
MEASURE THE RESISTANCE OF THE BAS SOLENOID VALVE CONTROL CIRCUIT
With the ignition off.
Measure the resistance of the BAS Solenoid Valve Control circuit from
the CAB harness connector to the BAS Brake Booster C2 harness
connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the BAS Solenoid Valve Control circuit for an open.
Perform ABS VERIFICATION TEST.
3.
MEASURE THE RESISTANCE OF THE BAS SOLENOID VALVE CIRCUITS
With the ignition off.
Measure the resistance between the BAS Solenoid Valve circuits at
the BAS Brake Booster C2 harness connector.
Is the resistance above 100k ohms?
Yes >> Go to 4
No >> Repair the BAS Solenoid Valve circuits for a short to each
other.
Perform ABS VERIFICATION TEST.
ZH