Chrysler 2005 Crossfire SRT6 Service Manual page 473

ZH
1331-BAS SOLENOID VALVE - RESISTANCE TOO HIGH (CONTINUED)
8.
MEASURE THE RESISTANCE OF THE BAS SOLENOID VALVE CONTROL CIRCUIT
With the ignition off.
Reconnect the CAB harness connector.
Measure the resistance between ground and the BAS Solenoid Valve
Control circuit.
Is the resistance 23.5 – 24.5k ohms?
Yes >> Replace the BAS Brake Booster. (Refer to 5 - BRAKES/
HYDRAULIC/MECHANICAL/POWER BRAKE BOOSTER -
REMOVAL).
No >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 307
ANTILOCK BRAKE -