Removal - Chrysler 2005 Crossfire SRT6 Service Manual

5 - 340 BRAKES - ABS SERVICE INFORMATION

REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, DISABLE
RESTRAINT SYSTEM BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, DRIVER
AIRBAG, PASSENGER AIRBAG, SIDE IMPACT
SENSOR, OR INSTRUMENT PANEL COMPONENT
DIAGNOSIS OR SERVICE. DISCONNECT AND ISO-
LATE THE BATTERY
CABLE, THEN WAIT TWO MINUTES FOR THE SYS-
TEM CAPACITOR TO DISCHARGE BEFORE PER-
FORMING FURTHER DIAGNOSIS OR SERVICE.
THIS IS THE ONLY SURE WAY TO DISABLE THE
SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE
TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
Note: Before starting this procedure, be certain to
turn the steering wheel until the front wheels are
in the straight-ahead position.
1. Place the front wheels in the straight ahead position.
2. Remove the clockspring from the steering column. (Refer to 8 - ELECTRICAL/RESTRAINTS/CLOCKSPRING -
REMOVAL).
3. Release the retension tabs (1) on the steering angle sensor.
4. With the tabs released, seperate the clockspring
(2) from the steering angle sensor (1).
THE SUPPLEMENTAL
NEGATIVE (GROUND)
ZH