Chrysler 2005 Crossfire SRT6 Service Manual page 444

5 - 278 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1201-BAS RELEASE SWITCH CIRCUIT (CONTINUED)
8.
MEASURE THE RESISTANCE BETWEEN GROUND AND THE BAS RELEASE SWITCH SENSOR
(RELEASED) CIRCUIT
Turn the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the BAS Release Switch
Sensor (Released) circuit at the BAS Brake Booster C2 harness con-
nector.
Is the resistance above 100k ohms?
Yes >> Go to 9
No >> Repair the BAS Release Switch Sensor (Released) circuit
for a short to ground.
Perform ABS VERIFICATION TEST.
9.
MEASURE THE RESISTANCE OF THE BAS RELEASE SWITCH SENSOR (RELEASED) CIRCUIT
With the ignition off.
Measure the resistance of the BAS Release Switch Sensor (Released)
circuit from the BAS Brake Booster C2 harness connector to the CAB
harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL)
Perform ABS VERIFICATION TEST.
No >> Repair the BAS Release Switch Sensor (Released) circuit
for an open.
Perform ABS VERIFICATION TEST.
ANTILOCK BRAKE -
ZH