Wiper Motor - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

(7) Wiper Motor

Wiper Motor
1. Remove the panel cover.
2. Disconnect the front wiper motor 4P connector.
3. Remove the wiper arm mounting nut (4) and wiper arm (1).
4. Remove the wiper link cap (5).
5. Remove the front wiper motor (2).
(When reassembling)
• When attaching the wiper arm (1) to the wiper motor (2),
assemble so that the dimensions are as given in the photo on
the left. After doing so, check if the wiper wipes symmetrically
on the left and right (bilateral symmetry).
Wiper arm mounting nut
Tightening torque
Wiper motor mounting
screw
(1) Wiper Arm
(2) Front Wiper Motor
(3) Wiper Blade
Rear Wiper Motor (If equipped)
1. Remove the wiper motor cover (7).
2. Disconnect the 4P connector from rear wiper motor (6).
3. Remove the wiper arm mounting nut (4) and wiper arm (3).
4. Remove the wiper link cap (1) and nut (2).
5. Remove the rear wiper motor mounting screws and the rear
wiper motor (6).
Wiper arm mounting nut
Tightening torque
Wiper motor mounting
screw
(1) Wiper Link Cap
(2) Nut
(3) Wiper Arm
(4) Nut
10-S54
7.9 to 9.8 N·m
0.80 to 1.0 kgf·m
5.8 to 7.2 lbf·ft
3.4 to 6.4 N·m
0.35 to 0.65 kgf·m
2.5 to 4.7 lbf·ft
(4) Nut
(5) Wiper Link Cap
9Y1211109CAS0079US0
7.9 to 9.8 N·m
0.80 to 1.0 kgf·m
5.8 to 7.2 lbf·ft
3.4 to 6.4 N·m
0.35 to 0.65 kgf·m
2.5 to 4.7 lbf·ft
(5) Wiper Blade
(6) Rear Wiper Motor
(7) Wiper Motor Cover
9Y1211109CAS0080US0
KiSC issued 11, 2014 A
CABIN