wsm STW37 Workshop Manual page 323

STW34, STW37, STW40, WSM
Fender (Right Side)
1. Remove the fender cover (2).
2. Remove the loader lever guide mounting nuts (5) and then open
the loader lever guide (4).
3. Disconnect the connectors for PTO switch (3) and beacon
switch (9).
4. Disconnect the clamp (7).
5. Remove the remote control valve lever bracket (1) with the
remote control valve lever.
6. Remove the lever guide (9).
7. Remove the screws (6).
8. Remove the fender mounting screw (8).
9. Disconnect the rear PTO switch connector (11).
(When reassembling)
Tightening torque Fender mounting screw
(1) Remote Control Valve Lever
Bracket
(2) Fender Cover
(3) PTO Switch
(4) Loader Lever Guide
(5) Loader Lever Guide Mounting Nut
Fender Assembly
1. Dismount the fender assembly (1) after checking whether there
is forgetting to disconnecting wiring.
(1) Fender Assembly
5-S9
BRAKES
197 to 225 N·m
20.0 to 23.0 kgf·m
145 to 166 psi
(6) Screw
(7) Clamp
(8) Screw
(9) Lever Guide
(10) Beacon Switch
(11) Rear PTO Switch Connector
9Y1211109TRS0023US0
9Y1211109TRS0024US0
KiSC issued 11, 2014 A