wsm STW37 Workshop Manual page 119

STW34, STW37, STW40, WSM
Wiring Harness (Rear Side)
1. Open the tool box (1).
2. Remove the clamps (2), (3) from the Cabin.
3. Disconnect the registration lamp connectors (4).
4. Disconnect the washer motor connectors (5).
5. Disconnect the PTO switch connector (6).
(When reassembling)
• Do not confuse the connectors.
– Connector (white) for the front washer motor.
– Connector (gray) for the rear washer motor.
(1) Tool Box
(2) Clamp
(3) Clamp
Differential Lock Pedal and Levers
1. Remove the differential lock pedal (1) with the spring (2).
2. Remove the grounding cable (6) mounting screws.
3. Remove the plate (3).
4. Remove the range gear shift lever (4) and cruise control lever
(5).
(1) Differential Lock Pedal
(2) Spring
(3) Plate
1-S40
ENGINE
(4) Registration Lamp Connector
(5) Washer Motor Connector
(6) PTO Switch Connector
9Y1211109ENS0051US0
(4) Range Gear Shift Lever
(5) Cruise Control Lever
(6) Grounding Cable
9Y1211109ENS0048US0
KiSC issued 11, 2014 A