wsm STW37 Workshop Manual page 255

STW34, STW37, STW40, WSM
Air Compressor and Oil Hoses
1. Disconnect the heater hoses (1), and then reconnect their
hoses to make loop.
NOTE
• Put a mark to the each heater hose before disconnecting.
2. Remove the air conditioner belt (4).
3. Disconnect the compressor 1P connector (2).
4. Disconnect the oil cooler inlet hose (6) and outlet hose (7).
5. Remove the battery stay mounting bolt.
6. Remove the compressor mounting screws.
7. Remove the compressor (3), condenser (9), receiver (5), battery
stay (8) and etc. as a unit.
(When reassembling)
• After reassembling the compressor, be sure to adjust the air
conditioner belt tension. (See page G-31.)
(1) Heater Hose
(2) Compressor 1P Connector
(3) Compressor
(4) Air Conditioner Belt
(5) Receiver
Cabin Assembly
1. Remove the outer roof (1) of cabin.
2. Support the cabin with nylon straps (2), cabin dismounting tool
(3) and hoists.
3. Loosen and remove the cabin mounting screw (4) and nuts (10).
4. Dismounting the cabin from tractor body.
NOTE
• Lift the cabin while making sure it does not catch on
anything.
(When reassembling)
• Be sure to install the washers and mount rubbers, etc. in their
original positions.
Outer roof mounting screw
Tightening torque
Cabin mounting bolt and
nut
(1) Outer Roof
(2) Nylon Strap
(3) Cabin Dismounting Tool
(4) Screw
(5) Plate
(6) Mount Rubber
(7) Collar
3-S41
TRANSMISSION
(6) Oil Cooler Inlet Hose
(7) Oil Cooler Outlet Hose
(8) Battery Stay
(9) Condenser
9Y1211109ENS0054US0
3.5 to 4.0 N·m
0.36 to 0.40 kgf·m
2.6 to 2.9 lbf·ft
124 to 147 N·m
12.6 to 15.0 kgf·m
91.1 to 108 lbf·ft
(8) Plane Washer
(9) Spring Washer
(10) Nut
(11) Collar
F: Front Side
R: Rear Side
9Y1211109ENS0055US0
KiSC issued 11, 2014 A