wsm STW37 Workshop Manual page 108

STW34, STW37, STW40, WSM
Clutch Assembly
1. Remove the clutch mounting screws and remove the clutch
assembly (1) from the flywheel (4).
(When reassembling)
• Direct the shorter end of the clutch disc boss toward the
flywheel (4).
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of clutch disc boss.
• Screws in two reamer screws (3) in the reamer screw holes (7).
• After tightening the reamer screws (3), tighten the other general
screws.
IMPORTANT
• Align the center of clutch disc (5) and flywheel (4) by
inserting the clutch center tool (2).
NOTE
• Do not allow grease and oil on the clutch disc facing.
• The reamer screw hole (7) on the clutch cover is in the next
of the 5 mm (0.2 in.) dia. hole.
• The shape of the reamer screw hole (7) on the flywheel (4)
is different from other screw holes.
Tightening torque Clutch mounting screw
(1) Clutch Assembly
(2) Clutch Center Tool
(3) Reamer Screw
(4) Flywheel
Separating Front Axle Assembly and Outer Parts
1. Remove the muffler (1).
2. Remove the alternator (2).
3. Disconnect the radiator hoses (3), (4).
4. Remove the recovery tank (5) with stay.
5. Remove the fuel filter (6).
6. Remove the hydraulic pump (7) with regulator valve.
7. Remove the engine mounting screws and separate the front
axle assembly from engine.
(When reassembling)
Muffler mounting screw
Tightening torque
Front axle frame
mounting screw (M12)
(1) Muffler
(2) Alternator
(3) Radiator Lower Hose
(4) Radiator Upper Hose
1-S29
ENGINE
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.2 lbf·ft
(5) Clutch Disc
(6) Clutch Cover
(7) Screw Hole for Reamer Screw
9Y1211109ENS0034US0
32 to 37 N·m
3.2 to 3.8 kgf·m
24 to 27 lbf·ft
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(5) Recovery Tank
(6) Fuel Filter
(7) Hydraulic Pump
9Y1211109ENS0035US0
KiSC issued 11, 2014 A