Control Panel (Blower Switch, A/C Switch, Mode Control Dial And Temperature Control Dial) - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM
(2) Control Panel (Blower Switch, A/C Switch, Mode Control Dial and
Temperature Control Dial)
Blower Switch Connector Voltage
1. Disconnect the 6P connector (2) from blower switch.
2. Turn the main switch to "ON" position.
3. Measure the voltage with a voltmeter across the connector
terminal a and terminal b.
4. If the voltage differs from the battery voltage, the wiring harness,
A/C relay, fuse or main switch is faulty.
Voltage Terminal a – Terminal b
(1) Control Panel
(2) 6P Connector
Blower Switch Test
1. Check the continuity through the switch with an ohmmeter.
2. If the continuity specified below are not indicated, the switch is
faulty.
(A) 6P Connector
(Blower Switch Side)
10-S24
Approx. battery voltage
(A) 6P Connector (Wire Harness
Side)
9Y1211109CAS0036US0
9Y1211109CAS0037US0
KiSC issued 11, 2014 A
CABIN