Disassembling And Assembling; Starter - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

[2] DISASSEMBLING AND ASSEMBLING

(1) Starter

Disassembling Motor
1. Disconnect the connecting lead (9) from the magnet switch (8).
2. Remove the screws (6), and then separate the end frame (4),
yoke (2) and armature (1).
3. Remove the two screws (5), and then remove the brush holder
(3) from the end frame (4).
(When reassembling)
• Apply grease to the spline teeth "A" of the armature (1).
(1) Armature
(2) Yoke
(3) Brush Holder
(4) End Frame
(5) Screw
(6) Screw
Disassembling Magnet Switch
1. Remove the drive end frame (1) mounting screws.
2. Remove the overrunning clutch (2), ball (3), spring (4), gears
(5), rollers (6) and retainer (7).
(When reassembling)
• Apply grease to the gear teeth of the gears (5) and overrunning
clutch (2), and ball (3).
(1) Drive End Frame
(2) Overrunning Clutch
(3) Ball
(4) Spring
Plunger
1. Remove the end cover (1).
2. Remove the plunger (2).
(1) End Cover
9-S42
ELECTRICAL SYSTEM
(7) Nut
(8) Magnet Switch
(9) Connecting Lead
A: Spline Teeth
WSM000001ELS0020US0
(5) Gear
(6) Roller
(7) Retainer
WSM000001ELS0021US0
(2) Plunger
WSM000001ELS0022US0
KiSC issued 11, 2014 A