Checking, Disassembling And Servicing; Checking And Adjusting - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

4. CHECKING, DISASSEMBLING AND SERVICING

[1] CHECKING AND ADJUSTING

Brake Pedal Free Travel
CAUTION
• Stop the engine and chock the wheels before checking
brake pedal.
• The difference between the right and left pedal plays must
be less than 5.0 mm (0.19 in.).
1. Release the parking brake.
2. Slightly depress the brake pedals (1) and measure free travel
"L" at top of pedal stroke.
3. If the measurement is not within the factory specifications,
loosen the lock nut (2) and turn the brake rod (3).
4. Retighten the lock nut (2) securely.
Brake pedal free travel
Factory specification
"L"
(1) Brake Pedal
(2) Lock Nut
(3) Brake Rod
Parking Brake Lever Free Play
1. Support the rear axle with the disassembling stand to separate
the rear wheels from the ground.
2. Shift the range gear shift lever to the neutral position, and
disengage the front wheel drive lever.
3. Raise the parking brake lever (1) until the ratchet sound is heard
once.
4. Check right and left rear wheels. Right and left rear wheels
should be free.
5. Next, raise the parking brake lever (1) until the ratchet sound is
heard twice.
6. Check right and left rear wheels. Right and left rear wheels
should be locked.
7. If it is not, adjust with the parking brake rod 2 (2).
Parking brake lever free
Factory specification
play
IMPORTANT
• Check the brake pedal free play after adjusting the parking
brake.
(1) Parking Brake Lever
5-S4
BRAKES
20 to 30 mm
0.79 to 1.18 in.
L: Free Travel
9Y1211109BRS0003US0
The brake works when the
lever is raised until the
ratchet sound is heard
twice
(2) Parking Brake Rod 2 (Left)
9Y1211109BRS0004US0
KiSC issued 11, 2014 A