Alternator - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

(2) Alternator

Pulley
1. Secure the hexagonal end of the pulley shaft with a
double-ended ratchet wrench as shown in the figure.
2. Loosen the pulley nut with a socket wrench and remove it.
(When reassembling)
Tightening torque Pulley nut
Rear End Cover
1. Remove the three rear end cover screws and the B terminal nut,
and remove the rear end cover.
Brush Holder
1. Remove the two screws holding the brush holder, and remove
the brush holder (1).
(1) Brush Holder
IC Regulator
1. Remove the three screws holding the IC regulator, and remove
the IC regulator (1).
(1) IC Regulator
Rectifier
1. Remove the four screws holding the rectifier and the stator lead
wires.
2. Remove the rectifier (1).
(1) Rectifier
9-S43
ELECTRICAL SYSTEM
58.4 to 78.9 N·m
5.95 to 8.05 kgf·m
43.1 to 58.2 lbf·ft
WSM000001ELS0023US0
WSM000001ELS0024US0
WSM000001ELS0025US0
WSM000001ELS0026US0
WSM000001ELS0027US0
KiSC issued 11, 2014 A