Disassembling And Assembling; Separating Front Axle Assembly - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

[2] DISASSEMBLING AND ASSEMBLING

(1) Separating Front Axle Assembly

Draining Front Axle Case Oil
1. Place the oil pans underneath the front axle case.
2. Remove the both right and left hand side drain plugs (2) and
filling plug (1) to drain the oil.
3. After draining, reinstall the drain plugs (2).
4. Fill new oil with specified amount of oil.
(When refilling)
• Pour new oil with specified amount.
Front axle case oil Capacity
(1) Filling Plug
Propeller Shaft
1. Loosen the clamp screws (1) and slide the propeller shaft cover
(2).
2. Tap out the spring pin (3) and then slide the coupling (4).
3. Remove the propeller shaft with the cover.
(When reassembling)
• Apply grease to the spline portion of the propeller shaft and
couplings.
• When inserting the spring pins (3), face their splits in the
direction parallel to the propeller shaft.
• Tighten the clamp screws (1) upward from the bottom side.
(1) Clamp Screw
(2) Propeller Shaft Cover
Front Wheel Turning Angle Sensor
1. Remove the wire harness clamp (4).
2. Disconnect the connector (1).
3. Remove the cotter pin and disconnect the arm (3) from the
sensor lever (2).
IMPORTANT
• Route the wire harness under the both power steering
hoses.
(1) Connector
(2) Lever
6-S5
FRONT AXLE
4.5 L
4.8 U.S.qts
4.0 Imp.qts
(2) Drain Plug
9Y1211109FAS0006US0
(3) Spring Pin
(4) Coupling
9Y1211109ENS0032US0
(3) Arm
(4) Clamp
9Y1211109FAS0007US0
KiSC issued 11, 2014 A