Steering Cylinder - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

(2) Steering Cylinder

Removing Steering Cylinder
• See page 6-S7.
Disassembling Steering Cylinder
1. Remove the rod joint (3) from the cylinder rod (2).
2. Draw out the cylinder cover (11).
3. Draw out the cylinder rod (2).
IMPORTANT
• Before insert the cylinder rod (2) with piston gasket (8),
through the piston gasket correcting tool (15) to prevent
damage the piston gasket (8).
• Apply clean transmission fluid to the piston gasket (8) and
bushing (9).
• Do not spin the cylinder rod (2) while inserting.
(When reassembling)
• Apply grease to the O-ring (10), rod gasket (12) and dust seal
(13).
• The plate (5) of cylinder tube (14) direction to front.
• Apply lock tight (Three Bod 1372D or equivalent) to the rod joint
(3).
• Be sure to check the toe-in after assembling. (See page 6-S4.)
Tightening torque Rod joint screw
(1) Power Steering Cylinder Assembly
(2) Cylinder Rod
(3) Rod Joint
(4) Tie Rod
(5) Plate
(6) External Snap Ring
(7) Piston
(8) Piston Gasket
7-S9
STEERING
9Y1211109STS0011US0
123.6 to 147.1 N·m
12.6 to 15.0 kgf·m
91.1 to 108.5 lbf·ft
(9) Bushing
(10) O-ring
(11) Cylinder Cover
(12) Rod Gasket
(13) Dust Seal
(14) Cylinder Tube
(15) Piston Gasket Correcting Tool
9Y1211109STS0012US0
KiSC issued 11, 2014 A