wsm STW37 Workshop Manual page 122

STW34, STW37, STW40, WSM
Wiring Harness (Right Side)
1. Disconnect the connectors for QGS controller (1) and flasher
unit (2).
2. Disconnect the coolant temperature sensor connector (7) and
glow plug cable (6).
3. Disconnect the connector for key stop solenoid (4), engine
revolution sensor (5) and front wheel angle sensor (8).
4. Disconnect the fuel return hoses (3) from the fuel tank.
(1) QGS Controller
(2) Flasher Unit
(3) Fuel Return Hose
(4) Key Stop Solenoid
Wiring Harness (Left Side)
1. Disconnect the connectors from the alternator (1), starter (4),
coolant temperature sensor and oil switch (2).
2. Disconnect the grounding terminal (5).
3. Remove the clamps (3), (6).
4. Set aside the main harness to the rear.
(1) Alternator
(2) Oil Switch
(3) Clamp
1-S43
ENGINE
(5) Engine Revolution Sensor
(6) Glow Plug Cable
(7) Coolant Temperature Sensor
(8) Front Wheel Angle Sensor
9Y1211109ENS0056US0
(4) Starter
(5) Grounding Terminal
(6) Clamp
9Y1211109ENS0057US0
KiSC issued 11, 2014 A