wsm STW37 Workshop Manual page 51

STW34, STW37, STW40, WSM
Cleaning Inner Air Filter [CAB Model]
Remove the inner filter, and blow air from the direction opposite
to the filter's normal air flow.
Pressure of compressed air must be under 205 kPa
2
(2.1 kgf/cm , 30 psi).
(1) Inner Air Filter
Cleaning Fresh Air Filter [CAB Model]
Remove the knob bolts and pull out filter.
NOTE
• Attach the filter and cover as the illustration above.
 Cleaning the air filter
• Normal use
Blow air from the opposite direction to the filter's normal air flow.
Pressure of compressed air must be under 205 kPa
2
(2.1 kgf/cm , 30 psi).
IMPORTANT
• Do not hit the filter. If the filter becomes deformed, dust
may enter into the air-conditioner, which may cause
damage and malfunction.
NOTE
• If the filter is very dirty:
Dip the filter in lukewarm water with mild dish washing
detergent. Move it up and down as well as left and right to
loosen dirt. Rinse the filter with clean water and let it
air-dry.
IMPORTANT
• Do not use gasoline, thinner or similar chemicals to clean
the filter as damage to the filter may occur.
• It may also cause an unpleasant odor in the CAB when the
system is used next.
(1) Fresh Air Filter
(2) Cover
(3) Knob Bolt
Checking Air Conditioner Condenser [CAB Model]
Check air conditioner condenser to be sure it is clean ofdebris.
(1) Air Conditioner Condenser
G-32
GENERAL
(2) Screw
9Y1211109GEG0080US0
(A) Air Inlet Port
(B) "AIR CONDITIONER AIRFLOW"
9Y1211109GEG0081US0
9Y1211109GEG0082US0
KiSC issued 11, 2014 A