Flasher Unit; Head Light - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

(23) Flasher Unit

(24) Head Light

Flasher Unit Terminal Voltage
1. Disconnect the battery negative cable, and remove the hood
and side cover.
2. Disconnect the flasher unit connector (2) and connect the
battery ground cable.
3. Measure the voltage with a voltmeter between 12 terminal and
7 terminal, between 13 terminal and 7 terminal.
4. If the voltage differs from the battery voltage, the wiring harness
is faulty.
12 terminal – 7 terminal
Voltage
4 terminal – 7 terminal
(Reference)
0.5 Y
1
0.85 Y
2
–
3
0.85 W/G
4
0.5 G
5
0.5 G/R
6
0.5 B
7
0.5 Sb
8
0.5 G/Y
9
0.5 G/B
10
0.5 W/L
11
1.25 R/B
12
–
13
(1) Flasher Unit
(2) Flasher Unit Connector
(3) Connector (Harness Side)
Adjustment of Optical Axis
1. Turn the adjustment screws (1), (2) and nuts (3) to the clockwise
or counterclockwise.
2. Regarding the direction of optical axis shown in the table below.
Clockwise Inside
Counterclockwise Outside
(1) Screw
(2) Screw
(3) Nut
(4) Head Light
9-S37
ELECTRICAL SYSTEM
Approx. battery voltage
Approx. battery voltage
Lighting switch
Licence Light
–
Main switch (IG)
Turn signal light (R)
Turn signal light switch (R)
Ground
Turn signal light (L)
Turn signal light switch (L)
Trailer
Hazard switch
Battery Voltage
–
[A] ROPS Model
[B] Cabin Model
9Y1211109ELS0067US0
(1) (2)
Outside
Inside
A: Clockwise
B: Counterclockwise
a: Up
b: Outside
c: Down
d: Inside
9Y1211109ELS0081US0
KiSC issued 11, 2014 A
(3)
Up
Down