wsm STW37 Workshop Manual page 298

STW34, STW37, STW40, WSM
Rear Wheel
1. Place the disassembling stand under the rear axles.
2. Remove the rear wheels (1).
3. Remove the Registration plate (3) with trailer electrical outlet
(2).
4. Remove the combination lights (4)
Rear wheel mounting
Tightening torque
screw and nut
(1) Rear Wheel
(2) Trailer Electrical Outlet
ROPS
1. Fold the ROPS and support it with the lift strap.
2. Remove the ROPS mounting bolts (1).
3. Pull out the ROPS.
Tightening torque ROPS mounting bolt
(1) ROPS Mounting Bolt
Lever Grip and Wiring Harness
1. Remove the grips of the rear PTO shift lever (2), position control
lever (1), cruise control lever (5) and range gear shift lever (6).
2. Remove the remote control valve lever guide (3)
3. Pull out the seat switch connector (7).
4. Open the tool box (4).
5. Disconnect the clamps (8).
(When reassembling)
• Do not confuse the grips.
– Grip (yellow) for the rear PTO shift lever (2).
– Grip (red) for the range gear shift lever (6).
(1) Position Control Lever
(2) Rear PTO Shift Lever
(3) Remote Control Valve Lever Guide
(4) Tool Box
4-S5
REAR AXLE
196.1 to 225.6 N·m
20.0 to 23.0 kgf·m
145 to 166 lbf·ft
(3) Registration Plate
(4) Combination Light
9Y1211109TRS0017US0
167 to 197 N·m
17.0 to 20.0 kgf·m
123 to 144 lbf·ft
9Y1211109TRS0018US0
(5) Cruise Control Lever
(6) Range Gear Shift Lever
(7) Seat Switch Connector
(8) Clamp
9Y1211109TRS0019US0
KiSC issued 11, 2014 A