Disassembling And Assembling - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

[3] DISASSEMBLING AND ASSEMBLING

Clutch Assembly
1. Remove the clutch mounting screws and remove the clutch
assembly (1) from the flywheel (4).
(When reassembling)
• Direct the shorter end of the clutch disc boss toward the
flywheel (4).
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of clutch disc boss.
• Screws in two reamer screws (3) in the reamer screw holes (7).
• After tightening the reamer screws (3), tighten the other general
screws.
IMPORTANT
• Align the center of clutch disc (5) and flywheel (4) by
inserting the clutch center tool (2).
NOTE
• Do not allow grease and oil on the clutch disc facing.
• The reamer screw hole (7) on the clutch cover is in the next
of the 5 mm (0.2 in.) dia. hole.
• The shape of the reamer screw hole (7) on the flywheel (4)
is different from other screw holes.
Tightening torque Clutch mounting screw
(1) Clutch Assembly
(2) Clutch Center Tool
(3) Reamer Screw
(4) Flywheel
Clutch Release Fork
1. Remove the set spring (1) from clutch release fork (2) and
release hub.
2. Remove the release bearing (3) with release hub (4).
(When reassembling)
• Set the clutch release fork (2) and release hub (4) with set
spring (1) in the correct direction.
(1) Set Spring
(2) Clutch Release Fork
2-S30
CLUTCH
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.2 lbf·ft
(5) Clutch Disc
(6) Clutch Cover
(7) Screw Hole for Reamer Screw
9Y1211109ENS0034US0
(3) Release Bearing
(4) Release Hub
9Y1211109CLS0006US0
KiSC issued 11, 2014 A