Disassembling And Servicing; Preparation; Separating Rear Axle For Rops - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

4. DISASSEMBLING AND SERVICING

[1] PREPARATION

(1) Separating Rear Axle for ROPS

Draining Transmission Fluid
1. Place an oil pan underneath the transmission case, and remove
the drain plugs (1).
2. Drain the transmission fluid.
3. Reinstall the drain plugs (1).
(When reassembling)
• Fill new oil from filling port after removing the filling plug (2) up
to the upper notch on the dipstick (3).
• After operating the engine for few minutes, stop it and check the
oil level again, if low, add oil prescribed level.
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-8
• Never work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed for
a few minutes to prevents damage to the transmission.
• Do not mix different brands oil together.
Transmission fluid Capacity
(1) Drain Plug
(2) Filling Plug
Seat and Seat Under Cover
1. Disconnect the seat switch connector (2).
2. Remove the seat (1).
3. Remove the step mat (6).
4. Remove the dipstick (5).
5. Remove the grips of the mid PTO lever (3) and front wheel drive
lever (4).
6. Remove the lowering speed adjusting knob (8).
7. Remove the seat under cover (7).
(1) Seat
(2) Seat Switch Connector
(3) Mid PTO Lever
(4) Front Wheel Drive Lever
4-S4
REAR AXLE
24 L
6.3 U.S.gals
5.3 Imp.gals
(3) Dipstick
9Y1211109ENS0020US0
(5) Dipstick
(6) Step Mat
(7) Seat Under Cover
(8) Lowering Speed Adjusting Knob
9Y1211109RAS0001US0
KiSC issued 11, 2014 A