Separating Rear Axle For Cabin - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

(2) Separating Rear Axle for CABIN

Rear Axle
1. Remove the setting screw (2) and pull out the lower link pin (3).
2. Place the disassembling stand under the rear axle case.
3. Remove the rear axle mounting screws and nuts, and separate
the rear axle (1).
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to the
joint face of the rear axle case and transmission case.
(1) Rear Axle
(2) Setting Screw
Draining Transmission Fluid
1. Place an oil pan underneath the transmission case, and remove
the drain plugs (1).
2. Drain the transmission fluid.
3. Reinstall the drain plugs (1).
(When reassembling)
• Fill new oil from filling port after removing the filling plug (2) up
to the upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the
oil level again, if low, add oil prescribed level.
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-8.
• Never work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed for
a few minutes to prevents damage to the transmission.
• Do not mix different brands oil together.
Transmission fluid Capacity
(1) Drain Plug
(2) Filling Plug
4-S10
REAR AXLE
(3) Lower Link Pin
(4) Brake Plate 2
9Y1211109RAS0008US0
24 L
6.3 U.S.gals
5.3 Imp.gals
(3) Dipstick
9Y1211109ENS0131US0
KiSC issued 11, 2014 A