wsm STW37 Workshop Manual page 544

STW34, STW37, STW40, WSM
Hub Plate
1. Three stopper bolts (1) are set in stopper magnetic clutch (2) at
the position corresponding to the shape of compressor.
2. The stopper magnetic clutch (2) is hung on hub plate (3) and it
is fixed that the compressor rotates.
3. Remove the magnetic clutch mounting screw.
4. Remove the hub plate (3) and air gap adjustment shim (4).
(When reassembling)
• Do not apply grease or oil on the hub plate facing.
• Do not use the magnetic clutch mounting screw again.
• Make sure to turn rotor by hand after assembling and not
contact with stator and hub plate.
• Check and adjust the air gap before tight the magnet clutch
mounting screw to the specified torque.
Magnetic clutch mounting
Tightening torque
screw
(1) Stopper Bolt
(2) Stopper Magnetic Clutch
Rotor
1. Remove the external circlip (1).
2. Remove the rotor (2).
(When reassembling)
• Do not use the external circlip again.
• Assemble the external circlip for the tapered side to become
outside of rotor.
• The width of expanding of external circlip is set in boss of shaft
as a minimum.
(Reference)
• Code No. for external circlip: T1065-87450
(1) External Circlip
Stator
1. Remove the lead wire (6) from compressor body.
2. Remove the external circlip (2).
3. Remove the stator (1).
(When reassembling)
• Do not use the external circlip again.
• Assemble the external circlip for the tapered side to become
outside of front housing.
• The width of expanding of external circlip is set is boss of shaft
as a minimum.
• Match and assemble the concave part (4) of the front housing
(3) and the pin (5) of stator.
(Reference)
• Code No. for external circlip: T1065-87440
(1) Stator
(2) External Circlip
(3) Front Housing
10-S45
15 to 21 N·m
1.5 to 2.1 kgf·m
11 to 15 lbf·ft
(3) Hub Plate
(4) Shim
9Y1211109CAS0056US0
(2) Rotor
9Y1211109CAS0057US0
(4) Concave Part
(5) Pin
(6) Lead Wire
9Y1211109CAS0058US0
KiSC issued 11, 2014 A
CABIN