Switches For Indicator Lamps; Pressure) - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM
(26) Switches for Indicator Lamps (Rear PTO, Mid PTO, Parking Brake and Oil

Pressure)

PTO Switches
1. Disconnect the PTO switch 2P connector.
2. Measure the resistance of 2P connector (switch side).
3. If the measurement differs from the table, replace it.
PTO Switch
Rear PTO gear shift
lever in neutral
position
Rear PTO switch (1)
Rear PTO gear shift
lever in 1st or 2nd
speed position
Mid PTO gear shift
lever at OFF position
Mid PTO switch (3)
PTO gear shift lever at
ON position
NOTE
• Rear PTO switch and mid PTO switch are the same parts.
(1) Rear PTO Switch
(2) 2P Connector
Parking Brake Switch
1. Disconnect the connector from the parking brake switch (1) after
turning the main switch OFF.
2. Measure the resistance across the two terminals.
3. If the measurement differs from the table below, the replace the
switch.
Parking lever at off position
Resistance (Across
switch terminals)
Parking lever pulled up
(1) Parking Brake Switch
(2) Connector of Parking Brake Switch
9-S39
ELECTRICAL SYSTEM
State Resistance
Infinity
0 Ω
Infinity
0 Ω
(3) Mid PTO Switch
(4) 2P Connector
9Y1211109ELS0070US0
Infinity
0 Ω
(3) Seat
9Y1211109ELS0071US0
KiSC issued 11, 2014 A