wsm STW37 Workshop Manual page 552

STW34, STW37, STW40, WSM
Front Windshield
NOTE
• Apply the Sika Flex 250PC (or equivalent) with the jig
having the specified tip shape as shown in the figure left.
• Apply it with a uniform speed to minimize unevenness.
• Follow the instruction manual of Sika Flex 250PC.
1. Apply the Sika Primer 250PC on the cabin frame "A" and "B"
in the figure.
2. Apply the Sika Flex 250PC (4) on the windshield "A" and "B" in
the figure.
3. Install the lower (left or right) windshield to the cabin and fix it
with a gummed tape.
4. Set the upper windshield to the cabin and fix it with a gummed
tape.
NOTE
• Use a jig (7) shown in the figure to create even clearance
"E" [approx. 5 mm (0.2 in.)] between the lower and upper
windshield.
• The level unevenness between the upper and lower
windshields should be −1 to +1 mm (−0.04 to +0.04 in.) or
less at the windshield surface.
5. Leave it for one hour.
6. Remove the jig (7).
7. Install the H rubber (6) between the lower and upper windshield
(2), (3).
8. Apply the Shin Etsu silicon KE420 in H rubber (6).
9. Apply the Shin Etsu silicon KE420 on the edge of H rubber (6).
NOTE
• When the gummed tape is removed, the glass may be
displaced. In this case fix it again.
• Remove the gummed tape (adhesive tape) little by little to
make sure the bonding condition.
(1) Upper Windshield
(2) Lower Windshield (Right)
(3) Lower Windshield (Left)
(4) Sika Flex 250PC
(5) Jig
(6) H Rubber
(7) Jig
10-S53
A: 10 mm (0.39 in.)
B: 12 mm (0.47 in.)
C: 8 mm dia. (0.31 in. dia.)
D: 12 mm (0.47 in.)
E: 5 mm (0.2 in.)
F: −1.0 to +1.0 mm
(−0.04 to +0.04 in.)
G: 360 mm (14.2 in.)
H: 20 mm (0.8 in.)
I: 5 mm (0.2 in.)
9Y1211109CAS0078US0
KiSC issued 11, 2014 A
CABIN