wsm STW37 Workshop Manual page 329

STW34, STW37, STW40, WSM
Rear Axle
1. Remove the setting screw and pull out the lower link pin.
2. Place the disassembling stand under the rear axle case.
3. Remove the rear axle mounting screws and nuts, and separate
the rear axle (1).
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to the
joint face of the rear axle case (1) and transmission case.
• Fix the brake plate (2) to the rear axle case (1) with the liquid
gasket.
Tightening torque Brake case mounting screw
(1) Rear Axle
Brake Disc, Brake Plate and Brake Cam
1. Remove the brake disc (5), brake shaft (3), brake plate (1).
2. Remove the cam plate (8) and steel balls (6).
3. Remove the brake cam (7).
(When reassembling)
• Place the brake disc (5) so that the brake disc hole (4) should
be overlapped 50 % or more.
• Apply grease to the O-ring on the brake cam (7).
• Be sure to fix the brake cam (7) and cam plate (8).
(1) Brake Plate
(2) Brake Disc
(3) Brake Shaft
(4) Brake Disc Hole
(5) Brake Disc
5-S15
BRAKES
39.3 to 44.1 N·m
4.0 to 4.5 kgf·m
29.0 to 32.5 lbf·ft
(2) Brake Plate
9Y1211109RAS0013US0
(6) Steel Ball
(7) Brake Cam
(8) Cam Plate
9Y1211109BRS0011US0
KiSC issued 11, 2014 A