Checking, Disassembling And Servicing; Checking And Adjusting - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

4. CHECKING, DISASSEMBLING AND SERVICING

[1] CHECKING AND ADJUSTING

Checking Clutch Pedal Free Travel
CAUTION
• When checking, park the tractor on flat ground, apply the
parking brake, stop the engine and remove the key.
1. Slightly depress the clutch pedal (1) and measure free travel
"L" at top of the clutch pedal.
2. If the measurement is not within the factory specification, loosen
the lock nut and adjust the clutch rod (2) length.
IMPORTANT
• After adjustment, be sure to check the operation of the
safety switch (3). The engine should not start if the clutch
pedal is not fully depressed. Refer to "Safety Switches"
(page 9-S26) in ELECTRICAL SYSTEM section for the
safety switch.
Clutch pedal free travel
"L" on top of clutch Factory specification
pedal
(1) Clutch Pedal
(2) Clutch Rod
(3) Safety Switch (Clutch Pedal Switch)
2-S4
CLUTCH
20 to 30 mm
0.78 to 1.18 in.
L: Clutch Pedal Free Travel
9Y1211109CLS0004US0
KiSC issued 11, 2014 A