wsm STW37 Workshop Manual page 107

STW34, STW37, STW40, WSM
Propeller Shaft
1. Loosen the clamp screws (1) and slide the propeller shaft cover
(2).
2. Tap out the spring pin (3) and then slide the coupling (4).
3. Remove the propeller shaft with the cover.
(When reassembling)
• Apply grease to the spline portion of the propeller shaft and
couplings.
• When inserting the spring pins (3), face their splits in the
direction parallel to the propeller shaft.
• Tighten the clamp screws (1) upward from the bottom side.
(1) Clamp Screw
(2) Propeller Shaft Cover
Separating the Engine from Clutch Housing
1. Place the disassembling stands under the clutch housing and
engine oil pan.
2. Remove the starter.
3. Remove the engine mounting screws and nuts, and separate
the engine from the clutch housing.
(When reassembling)
• Apply liquid gasket (Three Bond 1211 or equivalent) to joint face
of the starter and rear end plate.
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of the engine and clutch housing.
Engine mounting screw,
bolt and nut (M10)
Tightening torque
Engine mounting nut (M12)
1-S28
ENGINE
(3) Spring Pin
(4) Coupling
9Y1211109ENS0032US0
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.5 to 41.2 lbf·ft
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.2 to 66.5 lbf·ft
9Y1211109ENS0033US0
KiSC issued 11, 2014 A