wsm STW37 Workshop Manual page 227

STW34, STW37, STW40, WSM
Operation Check of Cruise Control Automatic Release
1. Engage the cruise control lever (1) and make sure the following
operations.
2. The cruise control lever (1) should return to the home position,
when right and left brake pedals are pressed at the same time.
3. The cruise control lever (1) must not return when only one of
brake pedals is pressed.
4. When not operating like the above-mentioned, do the following
checks "1) Lever Setting Position", "2) Release Wire" and "3)
Brake Link".
(1) Cruise Control Lever
(2) Brake Pedal
1) Lever Setting Position (Cruise Control)
1. Engage the cruise control lever (1).
2. Make sure the release lever (2) touches the cruise control lever
(1) by the spring (6), and the cruise control lever (1) touches the
stopper (3).
3. When not becoming like the above mentioned, check the
release wire (7) and damage of the spring (6). (See 3-S14
"Release Wire".)
4. Check the clearance "A" between the claw (5) and lever guide
(4).
5. Check the projection height "H" of the claw (5) from the lever
guide (4).
6. If the clearance A is not within the factory specifications, remove
the left rear wheel and the fender cover, and adjust it with the
shim (7).
7. If the projection height "H" is not within the factory
specifications, loosen the screws (8) and move the cruise lever
assembly.
Clearance "A" between
Factory specification
the claw and lever guide
Projection height "H"
Factory specification
from the lever guide
(1) Cruise Control Lever
(2) Release Lever
(3) Stopper
(4) Lever Guide
(5) Claw
(6) Spring
(7) Release Wire
(8) Screw
3-S13
TRANSMISSION
(3) Pedal Lock
9Y1211109TRS0010US0
0 to 1 mm
0 to 0.039 in.
More than
2 mm
0.079 in.
A: Clearance between the claw and
lever guide
H: Projection height from the lever
guide
9Y1211109TRS0011US0
KiSC issued 11, 2014 A