wsm STW37 Workshop Manual page 233

STW34, STW37, STW40, WSM
Power Steering Hoses and Accelerator Wire (Right Side)
1. Disconnect the accelerator wire (1) from the engine.
2. Disconnect the fuel hose (2).
3. Disconnect the delivery hose L.H. (3) and delivery hose R.H. (4)
from the steering controller.
4. Disconnect the power steering delivery hose (6) from the
steering controller.
5. Disconnect the power steering return hose (5) from the steering
controller.
(When reassembling)
• Be sure to connect the each hose to original position.
• Be sure to check the hose joints do not interfere in other joints.
Delivery hose R.H. (4)
retaining nut
Delivery hose L.H. (3)
retaining nut
Tightening torque
Return hose retaining nut
Delivery hose joint screw
(1) Accelerator Wire
(2) Fuel Hose
(3) Delivery Hose L.H.
(4) Delivery Hose R.H.
(5) Power Steering Return Hose
(6) Power Steering Delivery Hose
Steering Support
1. Remove the screws (1).
2. Remove the screws (4).
3. Remove the steering support (2) with steering controller (3).
(1) Screw
(2) Steering Support
Panel Under Frame
1. Remove the foot covers (1).
2. Remove the screws (2) and nuts (4), and pull up the panel under
frame (3).
(1) Foot Cover
(2) Screw
3-S19
TRANSMISSION
24.5 to 29.4 N·m
2.5 to 3.0 kgf·m
18.1 to 21.7 lbf·ft
24.5 to 29.4 N·m
2.5 to 3.0 kgf·m
18.1 to 21.7 lbf·ft
34.3 to 44.1 N·m
3.5 to 4.5 kgf·m
25.3 to 32.5 lbf·ft
45.1 to 53.0 N·m
4.60 to 5.40 kgf·m
33.3 to 39.0 lbf·ft
(7) P Port
(8) LT Port
(9) RT Port
(10) T Port
[A] Viewed from Bottom Side
9Y1211109ENS0028US0
(3) Steering Controller
(4) Screw
9Y1211109ENS0025US0
(3) Panel Under Frame
(4) Nut
9Y1211109ENS0030US0
KiSC issued 11, 2014 A