wsm STW37 Workshop Manual page 327

STW34, STW37, STW40, WSM
Release Wire and Wiring Harness (Left Side)
1. Remove the fender under cover (1).
2. Remove the release wire (3).
3. Remove the lever guide mounting screws (2), and then open the
lever guide (4).
4. Disconnect the wiring connectors for the bi-speed controller
connectors (5) and electrical outlet connector (6).
5. Remove the lever guide (4) with bi-speed controller.
(1) Fender Under Cover
(2) Lever Guide Mounting Screw
(3) Release Wire (Cruise Control)
Cabin Mount Screw
1. Remove the grounding cable (2) mounting screws.
2. Remove the plate (1).
3. Place a stand (5) under the cabin frame.
4. Remove the cabin mount bracket mounting screw (3) and nut.
5. Remove the bracket (4).
(When reassembling)
• Be sure to install the washers, plate and mount rubbers, etc. in
their original positions.
Bracket mounting screw
M12
Tightening torque
Cabin mounting bolt and
nut
(1) Plate
(2) Grounding Cable
(3) Cabin Mounting Screw
(4) Bracket
(5) Stand
(6) Plate
5-S13
BRAKES
(4) Lever Guide
(5) Bi-speed Controller Connector
(6) Electrical Outlet Connector
9Y1211109ENS0047US0
63 to 72 N·m
6.4 to 7.4 kgf·m
47 to 53 lbf·ft
124 to 147 N·m
12.6 to 15.0 kgf·m
91.1 to 108 lbf·ft
(7) Mount Rubber
(8) Collar
(9) Plane Washer
(10) Nut
(11) Collar
9Y1211109RAS0010US0
KiSC issued 11, 2014 A