Check Points Of Initial 50 Hours - wsm STW37 Workshop Manual

STW34, STW37, STW40, WSM

[2] CHECK POINTS OF INITIAL 50 HOURS

Cleaning Air Conditioner Condenser Screen [CAB Model]
WARNING
To avoid personal injury or death:
• Be sure to stop the engine before removing the screen.
• The condenser and receiver become hot while the air
conditioner is running. Before checking or cleaning them,
wait enough until they cool down.
1. Detach the air conditioner condenser screen and remove all
foreign materials.
IMPORTANT
• Grill and screen must be clean from debris to prevent
engine from overheating and to allow good air intake for air
cleaner.
(1) Air Conditioner Condenser Screen
Changing Engine Oil
WARNING
To avoid personal injury or death:
• Be sure to stop the engine before changing the oil.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plug at the bottom of the
engine and drain the oil completely into the oil pan.
All the used oil can be drained out easily when the engine is still
warm.
2. After draining, reinstall the drain plug.
3. Fill with the new oil up to the upper notch on the dipstick.
(Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-8.)
IMPORTANT
• When using an oil of different maker or viscosity from the
previous one, remove all of the old oil.
• Never mix two different types of oil.
• If oil level is low, do not run engine.
Engine oil Capacity
(1) Drain Plug
(2) Dipstick
(3) Oil Inlet
G-16
9Y1211109GEG0074US0
5.7 L
STW34 6.0 U.S.qts
5.0 Imp.qts
6.7 L
STW37,
7.1 U.S.qts
STW40
5.9 Imp.qts
A: Oil level is acceptable within this
range.
9Y1211109GEG0008US0
GENERAL
KiSC issued 11, 2014 A