wsm STW37 Workshop Manual page 459

STW34, STW37, STW40, WSM
Front Wheel Turning Angle Sensor
1. Separate the arm (4) from angle sensor lever (5).
2. Disconnect the connector (1).
3. Remove the sensor with sensor cover (3), then remove the
sensor from sensor cover (3).
4. Measure the angle sensor resistance between the A terminal
(6) and ground C terminal (8).
5. Set the test lead of tester between B terminal (7) and ground C
terminal (8).
Turn the sensor lever (5) slowly and check the changing of
resistance value.
6. If measurement is not within the factory specifications, replace
it.
IMPORTANT
• If replaced a front wheel turning angle sensor, be sure to
operate the "Fine adjustment system".
Factory
Front wheel turning
specifi-
angle sensor resistance
cation
Factory
Changing of resistance
specifi-
value
cation
(1) Connector
(2) Front Wheel Turning Angle Sensor
(3) Sensor Cover
(4) Arm
9-S22
ELECTRICAL SYSTEM
A terminal –
4.32 to 6.48 kΩ
C terminal
B terminal –
Changing with smoothly
C terminal
(5) Lever
(6) A Terminal
(7) B Terminal
(8) C Terminal (Ground)
9Y1211109ELS0027US0
KiSC issued 11, 2014 A