wsm STW37 Workshop Manual page 240

STW34, STW37, STW40, WSM
Wiring Harness
1. Disconnect the brake light switch connector (1).
2. Remove the clamps (2).
3. Disconnect the connectors for parking brake switch (3) and Mid
PTO switch (4).
4. Disconnect the grounding cable (5)
5. Disconnect the safety switch for clutch pedal (7) and HST pedal
(6).
6. Set aside the main harness to the front.
(1) Brake Light Switch
(2) Clamp
(3) Parking Brake Switch
(4) Mid PTO Switch
Propeller Shaft
1. Loosen the clamp screws (1) and slide the propeller shaft cover
(2).
2. Tap out the spring pin (3) and then slide the coupling (4).
3. Remove the propeller shaft with the cover.
(When reassembling)
• Apply grease to the spline portion of the propeller shaft and
couplings.
• When inserting the spring pins (3), face their splits in the
direction parallel to the propeller shaft.
• Tighten the clamp screws (1) upward from the bottom side.
(1) Clamp Screw
(2) Propeller Shaft Cover
3-S26
TRANSMISSION
(5) Grounding Cable
(6) Safety Switch for HST Pedal
(7) Safety Switch for Clutch Pedal
9Y1211109TRS0025US0
(3) Spring Pin
(4) Coupling
9Y1211109ENS0032US0
KiSC issued 11, 2014 A