wsm STW37 Workshop Manual page 471

STW34, STW37, STW40, WSM
5) Turn Signal Light Switch when Setting Switch Knob at OFF
Position
1. Set the turn signal light switch to the OFF position.
2. Measure the resistance with an ohmmeter across the B2
terminal to the R terminal and the B2 terminal to the L terminal.
3. If infinity is not indicated, the turn signal light switch is faulty.
B2 terminal – R terminal
Resistance (Switch
at OFF position)
B2 terminal – L terminal
6) Turn Signal Light Switch when Setting Switch Knob at R
Position
1. Set the turn signal light switch to the R position.
2. Measure the resistance with an ohmmeter across the B2
terminal to the R terminal.
3. If 0 ohm is not indicated, the turn signal light switch is faulty.
Resistance (Switch
B2 terminal – R terminal
at R position)
7) Turn Signal Light Switch when Setting Switch Knob at L
Position
1. Set the turn signal light switch to the L position.
2. Measure the resistance with an ohmmeter across the B2
terminal to the L terminal.
3. If 0 ohm is not indicated, the turn signal light switch is faulty.
Resistance (Switch
B2 terminal – L terminal
at L position)
8) Horn Switch Continuity
1. Measure the resistance with an ohmmeter across the B2
terminal to the H terminal.
2. If measurement is not following below, the horn switch is faulty.
Resistance
B2 terminal – T terminal
(Switch at OFF)
Resistance
B2 terminal – 2 terminal
(Switch at ON)
9-S34
ELECTRICAL SYSTEM
Infinity
9Y1211109ELS0058US0
0 Ω
9Y1211109ELS0059US0
0 Ω
9Y1211109ELS0060US0
Infinity
0 Ω
9Y1211109ELS0061US0
KiSC issued 11, 2014 A