Remotes And Two-Way Keyfobs - Eaton Menvier 20 Administrator's And User Manual

Menvier30/40/100/300
When you complete the test check that the output is back in the
state it had before testing. For example, if the output was off before
testing, make sure it is off after testing.

Remotes and Two-way Keyfobs

1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
present a tag).
Press  until you see:.
4.
Press .
5.
The display shows:
Press  until you see:
6.
Press .
7.
The display asks you to press any
button on the remote (or or two-
way keyfob) you wish to test.
If there are no remotes or two-way
keyfobs available the display briefly
shows:
8. Press a button on the device you
wish to test (you should press and
hold the button down until the
transmit LED on the device
flashes).
The keypad gives a double "beep"
confirmation tone.
The top line of the display shows:
the number of the device, the
button you pressed, and the user
the device is allocated to. (The line
will show the user's name if it has
4. Administration


















Page 67