Adjustment In The Case Of Failure In Stacking Performance Of Tray (Run-On Of Paper When Using Thin Paper) - Canon Finisher-AK1 Service Manual

5
Adjustment > Adjustment at Time of Parts Replacement > Adjustment in the Case of Failure in Stacking Performance of Tray (run-on of paper when using thin paper) > Procedure
Adjustment in the Case of Failure in Stacking
Performance of Tray (run-on of paper when using thin
paper)
Execute this adjustment in the case of failure in stacking performance of the tray when using
thin paper as shown in the figure below or replacing the finisher controller PCB.
NOTE:
Executing this adjustment makes the finisher to reduce feeding speed of the paper.
This operation improves abovementioned failure in stacking performance of the tray
because of reduced curl-level with thin paper.
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
5 Adjustment > Adjustment at Time of Parts Replacement > Adjustment in the Case of Failure in Stacking Performance of Tray (run-on of paper when using thin paper) > Procedure
F-5-136
■ Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
2) Press switch SW385 [1] so that this adjustment is ready now.
SW382
SW381
SW383 SW384 SW385
(-) (+)
ENTER
F-5-137
ENTER
[1]
F-5-138
5-58
5-58