Right Angle Adjustment Of Alignment Plate - Canon Finisher-AK1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Right Angle Adjustment of Alignment Plate

Right Angle Adjustment of Alignment Plate

This adjustment is executed when replacing or installing/removing the Alignment Motor in the
Intermediate Process Tray Assembly or when replacing the Finisher Controller PCB.
Adjusting method is as follows:
1) After installing the intermediate process tray assembly, loosen the 2 screws [2] on the
alignment plate [1] in the intermediate process tray assembly.
[2]
2) Secure the 2 paper edge stoppers [1] with the 2 screws [2].
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Right Angle Adjustment of Alignment Plate
[1] [2]
F-4-182
[2]
[1]
F-4-183
3) After setting A4 paper [1] in the arrow direction of the intermediate tray assembly, make
adjustment so that there is no gap between the paper edge
[1] and the alignment plate [2], and then secure the alignment plate with
the screw [3].
[3]
[2]
[C]
[1]
4-77
[1]
[2]
[1]
F-4-184
4-77