Removing A Dc Power Supply From An Ocx1100 Switch; Figure 38: Installing A Dc Power Supply In An Ocx1100-48Sx Switch - Juniper OCX1100 Hardware Manual

OCX1100 Switch Hardware Guide

Documentation

Removing a DC Power Supply from an OCX1100 Switch

114

NOTE:

If you have a Juniper J-Care service contract, register any addition,

change, or upgrade of hardware components at

https://www.juniper.net/customers/csc/management/updateinstallbase.jsp

Failure to do so can result in significant delays if you need replacement parts.

This note applies if you change the type of power supply or add a new type

of uplink module. It does not apply if you replace these components with the

same type of component.

Removing a DC Power Supply from an OCX1100 Switch on page 114

DC Power Supply in OCX1100 Switches on page 25

Connecting DC Power to an OCX1100 Switch on page 82

OCX1100 Switches Hardware Overview on page 3

The power supply in OCX1100 switches is a hot-removable and hot-insertable

field-replaceable unit (FRU) installed in the rear panel of the switch: You can remove

and replace it without powering off the switch or disrupting switch functions.

Before you begin removing a power supply from the switch:

Ensure you understand how to prevent electrostatic discharge (ESD) damage. See

"Prevention of Electrostatic Discharge Damage" on page

Ensure that you have the following parts and tools available to remove the power supply

from the switch chassis:

ESD grounding strap

Phillips (+) screwdriver

An antistatic bag or an antistatic mat

Replacement power supply or a cover panel for the power supply slot

167.

Table of Contents